Time for the planting.
For film heaters, it is possible to grow up in a pothole on the window from 2 to 25 April to put it in the heater from 1 to 20 May.
If a cellular polycarbonate heater, there is no need to cultivate in domestic conditions. Russad grows straight into the heater in a small area of the team. The seeds are scattered on 20 April, and then 20 to 22 days (approximately 10 to 12 May) in the entire area of heaters, i.e. permanently. If the air temperature is reduced during the height of the draught, it shall be closed inside the heaters with a light film or special non-containing material.
The seeds shall be placed in the throats, glasses or bags of 8X8 or 10X10 cm.
One of the nutrient soil mixtures in the throats is added: 2 parts of the peat and bulkhead and 1 part of the petty old charcoal; 1 table spoon of nitrophos and 3 wooden beds; 1 part of the woodland, peat, pepper spray, or one part of the foam, and a peanut of the peat. Any soil mixture can be replaced by a ready " Living Land " , without adding fertilizers.
The e-mail mix is a good mixer, and the trust is blown into the pot. Then it is soaked (50 °C) with a solution (in 10 litres of water to dissolve 1 sodium cafeteria). If the soil mixture is sealed, we'll have to lay the ground down so that the pot is full. Before putting the ready-to-mouth combustibles in the greenhouse, the rig must be overclothesized, flattened, slightly lost, and must be sprayed with a copper plagoose solution (for 10 litres warm - 80 °C, the water takes 1 copper spoon for 2 litres per square meters). And only after that grief, they put one to one, a bridge, that is, close to each other. In the middle of the pot, they make a hole with a depth of 2 cm and sew one semester, then fall asleep with a soil mixture and cover a double layer of concealed material.
Russad grows 22 to 25 days, no more. The temperature of the night shall be maintained at not less than 12 to 14 °C, not less than 15 to 16 °C. We need to cover the warming up for the night, and the day of the additional hidden material is being removed. If the air temperature reaches 20 °C and above the day, the heater Dear 2DUM may be opened. On a warm day, in the phase of two of these sheets, we need to feed a solution: 10 litres of warm water take one glass of liquid cow and one tea spoon of urea or crystalline (2-3 litres per m2 of landing) or 1-2 table spoons of Ideala (2 litres per m2). During the production period, 1 to 2 times warm (30 °C) water shall be sludged at 2 to 3 litres per m2 of stream. It's 10 to 11 in the morning.